LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2014 >> Wrangler Sahara, Standard Trans >> Repair and Diagnosis >> Body & Frame >> Frames, Subframes & Crossmembers >> Frame And Bumpers >> Frame >> Standard Procedure >> Weld Nut Service >> Rear Stabilizer Bar

Rear Stabilizer Bar

Fig 1: Type 2 Nut
GC0131106Courtesy of CHRYSLER GROUP, LLC
M10 Locations:
Stabilizer bar (5)
M12 Locations:
Fuel Tank Frame Rail (4)
Transmission Skid Plate (2)
  1. Using a cut off wheel or equivalent, remove the rear stabilizer bolt with the damaged weld nut.
  2. Remove the damaged weld nut from the access hole in the in the frame rail (5).
  3. Position a new M10 type 2 nut into access hole in the frame rail and install the stabilizer bar bolt. Refer to STABILIZER BAR, REAR SUSPENSION, INSTALLATION .
scientia non olet · About LEMON Manuals