Diagnostic Test

CHECK FOR AN ACTIVE DTC
NOTE:
Verify the connection of the Hands Free Microphone harness connector.
1. Turn the ignition on.
2. With the scan tool, read the active DTCs.
  Does the scan tool display B143C-MICROPHONE 1 CIRCUIT HIGH as active?
  
  Yes
  - Go To 2
  No
  - Test complete, the condition or conditions that originally set this DTC are not present at this time. Using the wiring diagrams as a guide, check all related splices and connectors for signs of water intrusion, corrosion, pushed out or bent terminals and correct pin tension.
  - Perform the BODY VERIFICATION TEST. Refer to STANDARD PROCEDURE .
CHECK THE HANDS FREE MICROPHONE

Fig 1: Hands Free Microphone Harness Connector End View
Courtesy of CHRYSLER GROUP, LLC
1. Turn the ignition off.
2. Disconnect the Hands Free Microphone harness connector.
3. Turn the ignition on.
4. With the scan tool, read the active DTCs.
  Does the scan tool display B143C-MICROPHONE 1 CIRCUIT HIGH as active?
  
  Yes
  - Go To 3
  No
  - Replace the Hands Free Microphone in accordance with the Service Information.
  - Perform the BODY VERIFICATION TEST. Refer to STANDARD PROCEDURE .
CHECK THE (X712) MICROPHONE 1 IN (+) CIRCUIT FOR A SHORT TO VOLTAGE

Fig 2: Checking Microphone 1 IN (+) Circuit For A Short To Voltage
Courtesy of CHRYSLER GROUP, LLC
1. Turn the ignition off.
2. Disconnect the Hands Free Module C1 harness connector.
3. Turn the ignition on.
4. Measure the voltage of the (X712) Microphone circuit.
  Is the voltage above 1.0 volt?
  
  Yes
  - Repair the (X712) Microphone circuit for a short to voltage.
  - Perform the BODY VERIFICATION TEST. Refer to STANDARD PROCEDURE .
  No
  - Replace the Hands Free Module in accordance with the Service Information.
  - Perform the BODY VERIFICATION TEST. Refer to STANDARD PROCEDURE .