Audio/Video/Entertainment/Connectivity (Service Information): Radio: Description: Description

Interaction with the radio features is done through the ISC screen module and switch bank located in the center stack of the instrument panel.

RADIO ANTI-THEFT CODE PROCEDURE The following is for vehicles that are equipped with power net or NTG4 radios. If the TGW or the radio have been removed or replaced, a four digit security code is required in order for the radio to function:

The key must be in the "RUN" position.
Press the "ON/VOL" control button.
The word "CODE" or " Please enter Anti-Theft Code" will appear on the display.
Enter the 4-digit code by pressing the corresponding preset buttons in sequence.

NOTE:

If three consecutive attempts are made to enter an invalid anti-theft code the radio will enter a 'WAIT' state. While in this state the radio display will read 'WAIT'. To exit the 'WAIT' state the radio must remain powered with the ignition in the run position for a continuous 30 minutes (the vehicle may be driven during this time). After exiting the 'WAIT' state the radio will again display 'CODE' and a valid anti-theft code may be entered.