LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2014 >> Wrangler Sahara, Standard Trans >> Repair and Diagnosis >> Accessories & Equipment >> Headlights >> Lamps/Lighting - Exterior (Service Information) >> Unit, Headlamp >> Removal >> Lamp - Export

Lamp - Export

Fig 1: Removing/Installing Headlamp Unit (Export)
GC0130813Courtesy of CHRYSLER GROUP, LLC
  1. Disconnect and isolate the battery negative cable.
  2. Remove the grille panel from the front of the vehicle. Refer to GRILLE, REMOVAL .
  3. Remove the four screws (4) that secure the retainer (3) and the headlamp unit (2) to the mounting collar (1) on the face of the front end module carrier.
  4. Pull the retainer and the headlamp unit away from the front of the vehicle far enough to access the wiring connection on the back of the lamp housing.
  5. Disconnect the engine compartment wire harness connectors from the headlamp bulb connector receptacle and from the position lamp bulb pigtail connector (5).
  6. Remove the headlamp unit from the vehicle.
scientia non olet · About LEMON Manuals