Lamp, Park And Turn Signal: Removal: Lamp

Fig 1: Identifying Park/Turn Signal Lamp

Courtesy of CHRYSLER GROUP, LLC

1. Disconnect and isolate the battery negative cable.
2. Reach behind the lower outboard corner of the grille panel (1) to access and release the two integral park/turn signal lamp (2) latch features (3) and push the lamp out through the face of the grille panel.
3. From the face of the grille panel, pull the lamp out far enough to access and disconnect the wire harness connector from the bulb socket connector receptacle (4) on the back of the lamp.
4. Remove the lamp from the vehicle.