Lamp - Export
Courtesy of CHRYSLER GROUP, LLC
- Disconnect and isolate the battery negative cable.
- Remove the license plate from the rear bumper cover (1).
- Reach under and behind the rear bumper to access and disconnect the license plate lamp pigtail wire harness connector (2) from the body wire harness.
- Remove the two screws (3) that secure the rear license plate lamp unit (4) to the rear bumper cover.
- Pull the license plate lamp unit away from the rear bumper cover far enough to disengage the pigtail wire harness from the clearance hole.
- Remove the bracket and lamp unit from the rear bumper cover.