Diagnostic Test

REPLACE THE TOTALLY INTEGRATED POWER MODULE IF DTC IS ACTIVE 

1. With the scan tool, read the active DTCs.

   Does the scan tool display this DTC as active?

   Yes 

   • Replace the Totally Integrated Power Module in accordance with the Service Information.
   • Perform the BODY VERIFICATION TEST. Refer to STANDARD PROCEDURE .

   No 

   • Test complete, the condition or conditions that originally set this DTC are not present at this time. Using the wiring diagrams as a guide, check all related splices and connectors for signs of water intrusion, corrosion, pushed out or bent terminals, and correct pin tension.