Diagnostic Test

1. With the scan tool, record and erase DTCs.
2. Cycle the ignition switch from off to on, leaving the ignition off for a minimum of 30 seconds.
3. With the scan tool, read the active DTCs.

   Does the scan tool display this DTC as active?

   Yes 

   • Go To  2

   No 

   • If the DTC is stored, check for an intermittent condition. Using the wiring diagram/schematic as a guide, visually inspect the related wiring harness connectors. Look for broken, bent, pushed out, or corroded terminals.

1. Verify IOD Fuse installed in TIPM

   Is IOD Fuse present?

   Yes 

   • Go To  3

   No 

   • Install the IOD Fuse.
   • Perform the BODY VERIFICATION TEST. Refer to STANDARD PROCEDURE .

Is IOD Fuse blown?

Yes 

• Replace the IOD Fuse.
• Perform the BODY VERIFICATION TEST. Refer to STANDARD PROCEDURE .

No 

• Test complete.