Diagnostic Test

INTERMITTENT CONDITION
1. Turn the ignition on.
2. With the scan tool, clear all DTCs.
3. Turn the Front Fog Lamps on.
4. With the scan tool, read DTCs.
  Does the scan tool display active DTC B16FC-FRONT RIGHT FOG LAMP CONTROL CIRCUIT LOW?
  
  Yes
  - Go To 2
  No
  - Test complete, the condition or conditions that originally set this DTC are not present at this time. Using the wiring diagrams as a guide, check all related splices and connectors for signs of water intrusion, corrosion, pushed out or bent terminals, and correct pin tension.
  - Perform the BODY VERIFICATION TEST. Refer to STANDARD PROCEDURE .
RIGHT FRONT FOG LAMP BULB
1. Turn the ignition off.
2. Disconnect the Right Front Fog Lamp bulb.
3. Turn the ignition on.
4. With the scan tool, read DTCs.
  Does the DTC reset?
  
  Yes
  - Go To 3
  No
  - Replace the Right Front Fog Lamp bulb in accordance with the Service Information.
  - Perform the BODY VERIFICATION TEST. Refer to STANDARD PROCEDURE .
(L90) RIGHT FRONT FOG LAMP CONTROL CIRCUIT SHORTED TO GROUND
1. Turn the ignition off.
2. Disconnect the TIPM C4 harness connector.
3. Measure the resistance between ground and the (L90) Right Front Fog Lamp Control circuit.
  Is the resistance above 10k Ohms?
  
  Yes
  - Replace the TIPM in accordance with the Service Information.
  - Perform the BODY VERIFICATION TEST. Refer to STANDARD PROCEDURE .
  No
  - Repair the short to ground in the (L90) Right Front Fog Lamp Control circuit.
  - Perform the BODY VERIFICATION TEST. Refer to STANDARD PROCEDURE .