Diagnostic Test

CHECK FOR AN ACTIVE DTC

NOTE:

Before proceeding with this diagnostic procedure, verify the Left and Right Multifunction Switch and Clockspring harness connectors are properly seated and verify proper pin terminal tension. A loose connection at any of these connectors may cause this DTC to set.

Turn the ignition on.
Actuate the Flash to Pass/Optical Horn.
With the scan tool, read DTCs.
Does the scan tool display this DTC as active?

Yes
- Replace the Left Multifunction Switch in accordance with the Service Information.
- Perform the BODY VERIFICATION TEST. Refer to STANDARD PROCEDURE .
No
- Test complete, the condition or conditions that originally set this DTC are not present at this time. Using the wiring diagrams as a guide, check all related splices and connectors for signs of water intrusion, corrosion, pushed out or bent terminals, and correct pin tension.