Removal - Right Cylinder Head

WARNING: This page is about a different variant/trim than selected.

Fig 1: Oil Fill Cap & Engine Cover

Courtesy of CHRYSLER GROUP, LLC

Remove the oil fill cap (1).
Remove the engine cover (2).

Fig 2: Negative Battery Cable
Courtesy of CHRYSLER GROUP, LLC
Perform the fuel pressure release procedure. Refer to FUEL SYSTEM PRESSURE RELEASE .
Disconnect and isolate the negative battery cable (2).

Fig 3: Cowl Panel Cover, Guide Pin, Tabs & Clips
Courtesy of CHRYSLER GROUP, LLC
Remove the cowl cover panel (2). Refer to COVER, COWL PANEL, REMOVAL .
Drain the cooling system. Refer to STANDARD PROCEDURE .
Remove the air cleaner and resonator assembly. Refer to BODY, AIR CLEANER, REMOVAL, 5.7L .

Fig 4: Cylinder Head Cover Removal/Tightening Sequence
Courtesy of CHRYSLER GROUP, LLC
Remove the cylinder head cover. Refer to COVER(S), CYLINDER HEAD, REMOVAL, 5.7L .
Remove the engine oil indicator tube retaining nut at the exhaust manifold and remove the oil indicator tube.

Fig 5: Intake Manifold Removal & Tightening Sequence
Courtesy of CHRYSLER GROUP, LLC
Remove the intake manifold. Refer to MANIFOLD, INTAKE, REMOVAL, 5.7L .

Fig 6: Rocker Shafts Retaining Bolt Removal & Tightening Sequence
Courtesy of CHRYSLER GROUP, LLC

NOTE:
The rocker arms and push rods must be installed in their original location as removed.
Remove the rocker arms and push rods. Note their location to ensure installation in their original locations. Refer to ROCKER ARM, VALVE, REMOVAL, 5.7L .

Fig 7: Cylinder Head Bolt Removal & Tightening Sequence
Courtesy of CHRYSLER GROUP, LLC
Using the sequence shown in illustration, remove the cylinder head bolts.
Remove the cylinder head and discard the cylinder head gasket.