LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2014 >> Grand Cherokee Laredo, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (5.7L Engine (Service Information)) >> Cylinder Head >> Removal >> Removal - Left Cylinder Head

Removal - Left Cylinder Head

WARNING: This page is about a different variant/trim than selected.
Fig 1: Oil Fill Cap & Engine Cover
GC0143807Courtesy of CHRYSLER GROUP, LLC
  1. Remove the oil fill cap (1).
  2. Remove the engine cover (2).
    Fig 2: Negative Battery Cable
    GC0145484Courtesy of CHRYSLER GROUP, LLC
  3. Perform the fuel pressure release procedure. Refer to FUEL SYSTEM PRESSURE RELEASE .
  4. Disconnect and isolate the negative battery cable (2).
    Fig 3: Cowl Panel Cover, Guide Pin, Tabs & Clips
    GC0146023Courtesy of CHRYSLER GROUP, LLC
  5. Remove the cowl cover panel (2). Refer to COVER, COWL PANEL, REMOVAL .
  6. Drain the cooling system. Refer to STANDARD PROCEDURE .
  7. Remove the air cleaner and resonator assembly. Refer to BODY, AIR CLEANER, REMOVAL, 5.7L  .
    Fig 4: Cylinder Head Cover Removal/Tightening Sequence
    GC0080292Courtesy of CHRYSLER GROUP, LLC

    Right side shown in illustration, left side similar. 

  8. Remove the cylinder head cover. Refer to COVER(S), CYLINDER HEAD, REMOVAL, 5.7L  .
    Fig 5: Intake Manifold Removal & Tightening Sequence
    GC0095568Courtesy of CHRYSLER GROUP, LLC
  9. Remove the intake manifold. Refer to MANIFOLD, INTAKE, REMOVAL, 5.7L  .
    Fig 6: Power Steering Pump & Return Hose
    GC0118699Courtesy of CHRYSLER GROUP, LLC
    NOTE:

    It is not necessary to disconnect the hoses from the power steering pump, for power steering pump removal.

  10. Remove the power steering pump (1) and position aside. Refer to PUMP, REMOVAL .
    Fig 7: Rocker Shafts Retaining Bolt Removal & Tightening Sequence
    GC0088038Courtesy of CHRYSLER GROUP, LLC

    Right side shown in illustration, left side similar. 

    NOTE:

    The rocker arms and push rods must be installed in their original location as removed.

  11. Remove the rocker arms and push rods. Note their location to ensure installation in their original locations as removed. Refer to ROCKER ARM, VALVE, REMOVAL, 5.7L  L.
    Fig 8: Cylinder Head Bolt Removal & Tightening Sequence
    GC0088039Courtesy of CHRYSLER GROUP, LLC

    Right side shown in illustration, left side similar. 

  12. Using the sequence shown in illustration, remove the cylinder head bolts.
  13. Remove the cylinder head and discard the cylinder head gasket.
scientia non olet · About LEMON Manuals