LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2014 >> Grand Cherokee Laredo, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (5.7L Engine (Service Information)) >> Cylinder Head >> Diagnosis And Testing >> Diagnosis And Testing - Cylinder Head Gasket Failure >> Cylinder-To-Water Jacket Leakage Test >> Cooling System Tester Method

Cooling System Tester Method

WARNING: This page is about a different variant/trim than selected.
CAUTION:

With the cooling system tester in place, pressure builds up fast. Excessive pressure built up by continuous engine operation must be released to a safe pressure point. Never permit pressure to exceed 138 kPa (20 psi).

Install the Cooling System Tester (special tool #7700, Tester, Cooling System) or equivalent to pressure cap neck. Start the engine and observe the tester's pressure gauge. If the gauge pulsates with every power stroke of a cylinder a combustion pressure leak is evident.

scientia non olet · About LEMON Manuals