LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2014 >> Grand Cherokee Laredo, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (3.0L Turbo Diesel (Service Information)) >> Lubrication >> Pan, Oil >> Removal >> Upper Oil Pan

Upper Oil Pan

WARNING: This page is about a different variant/trim than selected.
  1. Disconnect the negative battery cable.
  2. Remove bolts and the oil level indicator tube.
  3. Remove the front skid plate. Refer to PLATE, SKID, FRONT, REMOVAL .
  4. Remove the front suspension skid plate. Refer to PLATE, SKID, FRONT SUSPENSION, REMOVAL
  5. Remove bolt securing the power steering supply line.
  6. Remove the rear A/C compressor mounting bolt.
  7. Lower the vehicle.
    Fig 1: Engine Cover
    GC0146436Courtesy of CHRYSLER GROUP, LLC
  8. Remove the engine cover (1).
  9. Remove air cleaner body. Refer to BODY, AIR CLEANER, REMOVAL  .
    Fig 2: Pulleys, Tensioner & Drive Belt 3.0L
    GC0146633Courtesy of CHRYSLER GROUP, LLC
  10. Remove the serpentine belt (2). Refer to BELT, SERPENTINE, REMOVAL .
    Fig 3: A/C Compressor Removal/Installation
    GC0146793Courtesy of CHRYSLER GROUP, LLC
  11. Disconnect the A/C clutch wire harness connector (1).
  12. Support the A/C compressor, remove the nut (4), stud (3), and bolt (2) that secures the A/C compressor to the bracket and position aside the compressor.
  13. Remove the upper oil dip stick tube bolt.
    Fig 4: Front Axle Tube Bushing Mounting Bolt Nut, And RH Axle Bracket
    GC0145633Courtesy of CHRYSLER GROUP, LLC
  14. Remove the lower oil pan. Refer to PAN, OIL, REMOVAL  .
  15. If equipped with AWD, remove the front axle (1). Refer to REMOVAL .
    Fig 5: Steering Gear & Knuckle/Rotor Assembly
    GC0146172Courtesy of CHRYSLER GROUP, LLC
  16. Remove the steering gear (1). Refer to GEAR, REMOVAL .
    Fig 6: Crankshaft Position Sensor Connector
    GC0146607Courtesy of CHRYSLER GROUP, LLC
  17. Remove the four transmission-to-oil pan bolts.
  18. Remove bolts securing the transmission cooler liner to oil pan.
  19. Remove bolts and position aside the EHPS pump.
  20. Detach the starter wire harness to upper oil pan.
  21. Disconnect the Crankshaft Position Sensor (CKP) wire harness connector (1).
    Fig 7: Crankshaft Position Sensor Wiring Harness Bracket & Bolts
    GC0146606Courtesy of CHRYSLER GROUP, LLC
  22. Remove bolts attaching the CKP harness connector bracket to oil pan.
    Fig 8: Upper Oil Pan, Oil Pump Pick-Up Tube, Gasket & Bolts
    GC0146707Courtesy of CHRYSLER GROUP, LLC
  23. Remove the oil pump pick-up tube bolt (2).
  24. Remove bolts (1) and the upper oil pan (3).
  25. Remove and discard gasket (4).
scientia non olet · About LEMON Manuals