Standard Procedure - Bearing Selection Charts

WARNING: This page is about a different variant/trim than selected.

CONNECTING ROD BEARINGS - LARGE END

Connecting Rod Journal Diameter - Connecting Rod Large End	Bearing Half	Connecting Rod Journal Diameter - Crankshaft
		A	B	C
		67.500 - 67.494 mm	67.494 - 67.488 mm	67.488 - 67.482 mm
A 71.000 - 71.006 mm	Upper Bearing Shell	Red	Red	Blue
A 71.000 - 71.006 mm	Lower Bearing Shell	Red	Blue	Blue

B 71.006 - 71.012 mm	Upper Bearing Shell	Red	Blue	Blue
B 71.006 - 71.012 mm	Lower Bearing Shell	Blue	Blue	Yellow

C 71.012 - 71.018 mm	Upper Bearing Shell	Blue	Blue	Yellow
C 71.012 - 71.018 mm	Lower Bearing Shell	Blue	Yellow	Yellow

CRANKSHAFT BEARINGS

Cylinder Block Seat Diameter (Bed Plate)	Bearing Half	Crankshaft Main Journal Diameter
		A	B	C
		73.958 - 73.952 mm	73.952 - 73.946 mm	73.946 - 73.940 mm
A 78.000 - 78.006 mm	Upper Bearing Shell	Red	Red	Blue
A 78.000 - 78.006 mm	Lower Bearing Shell	Red	Blue	Blue

B 78.006 - 78.012 mm	Upper Bearing Shell	Red	Blue	Blue
B 78.006 - 78.012 mm	Lower Bearing Shell	Blue	Blue	Yellow

C 78.012 - 78.018 mm	Upper Bearing Shell	Blue	Blue	Yellow
C 78.012 - 78.018 mm	Lower Bearing Shell	Blue	Yellow	Yellow