LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2014 >> Grand Cherokee Laredo, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (3.0L Turbo Diesel (Service Information)) >> Cylinder Head >> Valves, Intake And Exhaust >> Standard Procedure >> Valve Service >> Disassembly

Valve Service: Disassembly

WARNING: This page is about a different variant/trim than selected.
  1. Remove the engine cylinder head from the cylinder block. Refer to CYLINDER HEAD, REMOVAL  .
  2. Use Valve Spring Compressor Tool (special tool #C-3422-D, Compressor, Valve Spring) and Valve Spring Compressor Adapter (special tool #10224, Adapter, Valve Spring) and compress each valve spring.
  3. Remove the valve locks, retainers, and springs.
  4. Use a smooth stone or a jewelers file to remove any burrs on the top of the valve stem, especially around the groove for the locks.
  5. Remove the valves, and place them in a rack in the same order as removed.
scientia non olet · About LEMON Manuals