Right Camshafts

WARNING: This page is about a different variant/trim than selected.

Fig 1: Camshaft Timing Tool & Sprockets Holes - Right

Courtesy of CHRYSLER GROUP, LLC

Disconnect the negative battery cable.
Remove the right timing chain and sprocket. Refer to CHAIN AND SPROCKETS, TIMING, REMOVAL .
Remove bolts and the right (special tool #VM.10343A-1, Alignment Tool, Cylinder Head (Right Intake)) (1).
Check the camshafts end play using (special tool #C-3339A, Set, Dial Indicator). End play should be between 0.1 mm - 0.3 mm (0.003 in. - 0.011 in.). If the camshaft endplay is not within specification, replace the cylinder head.

Fig 2: Right Side Intake & Exhaust Camshaft, Camshaft Bearing Caps & Bolts
Courtesy of CHRYSLER GROUP, LLC

NOTE:
Make a reference in the order the camshaft bearing caps were removed.
Remove bolts (3) and the intake and exhaust camshaft bearing caps (2).
Remove the right side intake and exhaust camshaft (1).