Diagnostic Test

CHECK FOR AN ACTIVE DTC 

1. Turn the ignition on.
2. Turn the Headlamps on.
3. Operate the Fog Lamp Switch several times.
4. With the scan tool, read DTCs.

   Does the scan tool display this DTC as active?

   Yes 

   • Replace the Headlamp Switch in accordance with the Service Information. Refer to SWITCH, HEADLAMP, REMOVAL .
   • Perform the BODY VERIFICATION TEST. Refer to STANDARD PROCEDURE .

   No 

   • Test complete, the condition or conditions that originally set this DTC are not present at this time. Using the wiring diagrams as a guide, check all related splices and connectors for signs of water intrusion, corrosion, pushed out or bent terminals, and correct pin tension.
   • Perform the BODY VERIFICATION TEST. Refer to STANDARD PROCEDURE .