Diagnostic Test

CHECK FOR AN ACTIVE DTC
1. Turn the ignition on.
2. Turn the High Beam Headlamps on.
3. With the scan tool, read DTCs.
  Does the scan tool display this DTC as active?
  
  Yes
  - Go To 2
  No
  - Test complete, the condition or conditions that originally set this DTC are not present at this time. Using the wiring diagrams as a guide, check all related splices and connectors for signs of water intrusion, corrosion, pushed out or bent terminals, and correct pin tension.
  - Perform the BODY VERIFICATION TEST. Refer to STANDARD PROCEDURE .
ATTEMPT TO SET THE OPPOSITE DTC
1. Turn the ignition off.
2. Disconnect the Left Front Lamp Assembly harness connector.
3. Turn the ignition on.
4. Turn the High Beam Headlamps on.
5. With the scan tool, read DTCs.
  Does the scan tool display DTC: B1632-15-LEFT HIGH BEAM CONTROL - CIRCUIT SHORT TO BATTERY OR OPEN?
  
  Yes
  - Replace the Left High Beam Bulb in accordance with the Service Information. Refer to UNIT, FRONT LAMP, REMOVAL .
  - Perform the BODY VERIFICATION TEST. Refer to STANDARD PROCEDURE .
  No
  - Go To 3
CHECK THE (L33) LEFT HIGH BEAM DRIVER CIRCUIT FOR A SHORT TO GROUND
1. Turn the ignition off.
2. Disconnect the BCM D harness connector.
3. Measure the resistance between ground and the (L33) Left High Beam Driver circuit.
  Is the resistance above 10k Ohms?
  
  Yes
  - Replace the BCM in accordance with the Service Information. Refer to MODULE, BODY CONTROL, REMOVAL .
  - Perform the BODY VERIFICATION TEST. Refer to STANDARD PROCEDURE .
  No
  - Repair the short to ground in the (L33) Left High Beam Driver circuit.
  - Perform the BODY VERIFICATION TEST. Refer to STANDARD PROCEDURE .