LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2012 >> Wrangler V6-3.6L >> Repair and Diagnosis >> Transmission and Drivetrain >> Drive Axles, Bearings and Joints >> Wheel Bearing >> Service and Repair >> Front Hub And Bearing - Installation

Front Hub And Bearing - Installation






INSTALLATION





1. Install the hub bearing to the knuckle.
2. Install the hub bearing to knuckle and the 3 bolts (3) then tighten to 102 Nm (75 ft.lbs.).
3. Install the axle nut if equipped. Tighten to 136 Nm (100 ft.lbs.).





4. Install the wheel speed sensor (1) through the hole in the brake shield (2).





5. Install the wheel speed sensor (1) into the hub and bearing and install the mounting bolt (2). Tighten to 4-6 Nm (34-50 in.lbs.).





6. Install the brake rotor (3).
7. Install the brake caliper adaptor (2).
8. Install the caliper (1).
9. Install the wheel and tire assembly.
10. Remove the support and lower the vehicle.
scientia non olet · About LEMON Manuals