Procedures

CHECKING TIE ROD ENDS

Tie rod free-play can be measured using the following hand methods:

NOTE: When checking free-play, DO NOT rotate the tie rod. Just because a tie rod rotates easily, it is not necessarily faulty.

NOTE: Always check and repair (if necessary) outer tie rod free-play before checking inner tie rod free-play. False results can otherwise be obtained.

Grasp the outer tie rod near the ball stud and attempt to move the tie rod straight up and down. If any free-play is felt, replace the outer tie rod Tie Rod End - Removal. If no free-play is felt at the outer tie rod, attempt to move the inner tie rod in the same manner. Refer to the following procedure.