LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2012 >> Wrangler V6-3.6L >> Repair and Diagnosis >> Engine, Cooling and Exhaust >> Engine >> Cylinder Block Assembly >> Piston >> Service and Repair >> Procedures >> Piston And Connecting Rod - Cleaning

Piston And Connecting Rod - Cleaning






CLEANING

CAUTION: DO NOT use a wire wheel or other abrasive cleaning devise to clean the pistons or connecting rods. The pistons have a Moly coating, this coating must not be damaged.

CAUTION: Do not remove the piston pin from the piston and connecting rod assembly.

1. Using a suitable cleaning solvent clean the pistons in warm water and towel dry.
2. Use a wood or plastic scraper to clean the ring land grooves.
scientia non olet · About LEMON Manuals