Bulb - Headlamp - Export
CAUTION:
Do not contaminate the bulb glass by touching it with your fingers or by allowing it to contact other oily surfaces. Shortened bulb life will result.
- Disconnect and isolate the battery negative cable.
- Disconnect the wire harness connector from the headlamp bulb base (3) on the back of the front lamp unit housing (1) located on the back of the front end module carrier.
- Remove the rubber boot seal (5) from the back of the front lamp unit housing and the headlamp bulb base.
- Pinch the two ends of the wire bulb retainer together and disengage them from the hooks that secure them to the bulb flange on the reflector.
- Pivot the wire retainer up off of the flange of the headlamp bulb base and out of the way.
- Pull the bulb straight out of the keyed opening in the headlamp reflector.