Lamp, Tail Stop Turn: Removal: Bulb
NOTE:
The rear lamp unit may contain up to four bulbs, depending upon the market for which the vehicle was manufactured. The service procedures for each bulb are the same, only the bulb sizes and types may differ.
- Disconnect and isolate the battery negative cable.
- Remove the rear lamp unit (1) from the rear body sheet metal. Refer to LAMP, TAIL STOP TURN, REMOVAL .
- Remove the two screws (2) that secure the socket plate (3) to the back of the rear lamp unit housing.
- Remove the socket plate from the rear lamp.
- Pull the base of the bulb straight out of the socket plate.