Backup Lamp Switch - Operation

OPERATION

The backup lamp switch controls a path to ground for the Totally Integrated Power Module (TIPM) on the reverse switch signal circuit. The TIPM reads this input through an internal pull-up, then controls an output through a high side driver that regulates the flow of battery voltage to the backup lamp bulbs as appropriate on the backup lamp feed circuit. The switch plunger is mechanically actuated by the gearshift mechanism within the transmission, which will depress the switch plunger and close the switch contacts whenever the REVERSE gear has been selected. The switch receives ground at all times through a take out and eyelet terminal of the unibody wire harness that is secured by a nut to a ground stud on the body sheet metal within the passenger compartment of the vehicle.

The backup lamp switch as well as the hard wired inputs and outputs of the switch may be diagnosed using conventional diagnostic tools and procedures. Refer to the appropriate wiring information.