Clutch Slave Cylinder - Removal

REMOVAL





1. With transmission in neutral, position vehicle on hoist.
2. Pull hydraulic line (2) clip from the slave cylinder.
3. Remove the line from the bracket and the cylinder.
4. Remove mounting nuts (1) from slave cylinder (3).
5. Remove the bracket from slave cylinder (3).

CAUTION: Do not allow release lever plunger to pivot more than 2° in either direction in the slave cylinder bore. Allowing the plunger to pivot more than 2° in the bore will cause fluid to bypass the seal and result in fluid leakage.

6. Remove slave cylinder by pulling straight back.