Water Pump Inlet Tube Elbow - Installation

WATER INLET TUBE ELBOW - INSTALLATION





1. Install new O-ring seal onto the water tube elbow.
2. Lubricate the O-ring seal with coolant to help aid in installation. Install elbow into the back side of the water pump.
3. Install the mounting bolts (1). Tighten the water pump bolts (1) to 12 Nm (106 in. lbs.).





4. Install the oil cooler hose (4).





5. Install the thermostat housing (4) Engine Coolant Thermostat - Installation.
6. Connect the negative battery cable.