F. Rear Swing Gate Latch Replacement (JK Models)

1. Open the swing gate.





2. Remove the access panel/grate (Figure 22).





3. Disconnect the swing gate latch electrical connector (Figure 23).

4. Disconnect the door link rods at the swing gate latch (Figure 23).





5. Remove the three swing gate latch retaining screws (Figure 24).

6. Remove and discard the original swing gate latch (Figure 25).





7. Install the new swing gate latch into the swing gate (Figure 25).

8. Install the three swing gate latch retaining screws (Figure 24).
Tighten the screws to 62 in. lbs. (5.5 N.m).

9. Connect the door link rods to the swing gate latch (Figure 23).

10. Connect the swing gate latch electrical connector.

11. Snap the access panel/grate into place (Figure 22).

12. Clean the swing gate panel using Mopar Glass Cleaner (P/N 04318014AB) or equivalent.