LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2011 >> Liberty Renegade, Part Time >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Body - Interior & Exterior >> Hood >> Prop, Gas >> Removal >> Removal

Prop, Gas: Removal: Removal

Fig 1: Support Cylinder Retaining Clip
GC0083748Courtesy of CHRYSLER LLC
1 - RETAINING CLIP
2 - BALL SOCKET
3 - BALL STUD
NOTE:

The support cylinders can be replaced one at a time.

  1. Open and support the hood.
    NOTE:

    Lift the clips only enough to release the ball studs.

    Fig 2: Support Cylinder-ball Socket-typical
    GC0092534Courtesy of CHRYSLER LLC
    1 - BALL SOCKET
    2 - RETAINING CLIP
    3 - FLAT BLADED TOOL
    4 - BALL STUD
  2. Using a small flat bladed tool, or equivalent, release the upper retaining clips while pulling the ball socket away from the ball stud.
    Fig 3: Removing/Installing Hood
    GC0086268Courtesy of CHRYSLER LLC
    CAUTION:

    Do not pull the supports from the middle while removing.

  3. Pulling at the ends only, remove the support cylinder.
scientia non olet · About LEMON Manuals