Seat Back, Rear: Assembly: Assembly

Fig 1: Cushion Cover - Hog Rings

Courtesy of CHRYSLER LLC

1 - SEAT FOAM CUSHION

2 - HOG RINGS

3 - SEAT CUSHION COVER

Position the seat back cushion on the frame and position the cover over the cushion.
Attach the seat cover (3) to the seat back cushion (1) and install new hog rings (2) as required.

Fig 2: Foam Insert
Courtesy of CHRYSLER LLC
Position the foam insert (2) back at the base of the seat back assembly (1).

Fig 3: Cover Zipper
Courtesy of CHRYSLER LLC
Zip the cover back over the frame.

Fig 4: Cover
Courtesy of CHRYSLER LLC
Install the push pin fasteners (3).
Position the inner cover (2) over the frame hooks (1).

Fig 5: J-straps
Courtesy of CHRYSLER LLC
Fasten the upper (1) and lower (2) zip strips at the bottom of the seat back.

Fig 6: Child Tether Bezels
Courtesy of CHRYSLER LLC
Install the child tether bezels (2) and install the screws (1).

Fig 7: Bolts & Latch
Courtesy of CHRYSLER LLC
Install the latch (1) and install the bolts (2).
Tighten the bolts to 28 N.m (21 ft. lbs.).

Fig 8: Latch Bezel
Courtesy of CHRYSLER LLC
Install the latch bezel (2) and install the screws (1).

Fig 9: Headrest Sleeve Install
Courtesy of CHRYSLER LLC
Install the headrest sleeves (2), if equipped.

Fig 10: Headrest
Courtesy of CHRYSLER LLC
Press the headrest sleeve release buttons and install the headrest, if equipped.
Install the seat back. Refer to SEAT BACK, Front, Installation and SEAT BACK, Rear, Installation .