Diagnostic Test

VERIFY DTC B1002-A/C SWITCH REQUEST INPUT CIRCUIT HIGH IS ACTIVE
1. Turn the ignition on.
2. With the scan tool, read DTCs.
  Does the scan tool display this DTC as active?
  
  Yes
  - Go to step 2
  No
  - Test complete, the condition or conditions that originally set this DTC are not present at this time. Using the wiring diagrams as a guide, check all related splices and connectors for signs of water intrusion, corrosion, pushed out or bent terminals, and correct pin tension.
  - Perform the BODY VERIFICATION TEST. Refer to DTC-Based Diagnostics/MODULE, Totally Integrated Power (TIPM) - Standard Procedure .
CHECK THE (C105) HVAC MUX CONTROL CIRCUIT FOR A SHORT TO VOLTAGE

Fig 1: Measuring Voltage Of HVAC MUX Control Circuit
Courtesy of CHRYSLER LLC
1. Turn the ignition off.
2. Disconnect the Cluster C2 harness connector.
3. Disconnect the A/C Heater Control C1 harness connector.
4. Turn the ignition on.
5. Measure the voltage of the (C105) HVAC MUX Control circuit.
  Is there any voltage present?
  
  Yes
  - Repair the short to voltage on the (C105) HVAC MUX Control circuit.
  - Perform the BODY VERIFICATION TEST. Refer to DTC-Based Diagnostics/MODULE, Totally Integrated Power (TIPM) - Standard Procedure .
  No
  - Go to step 3
CHECK THE (C105) HVAC MUX CONTROL CIRCUIT FOR AN OPEN

Fig 2: Measuring Resistance Of HVAC MUX Control Circuit
Courtesy of CHRYSLER LLC
1. Turn the ignition off.
2. Measure the resistance of the (C105) HVAC MUX Control circuit between the A/C Heater Control C1 harness connector and the Cluster C2 harness connector.
  Does the Ohm meter read open circuit?
  
  Yes
  - Repair the (C105) HVAC MUX Control circuit for an open.
  - Perform the BODY VERIFICATION TEST. Refer to DTC-Based Diagnostics/MODULE, Totally Integrated Power (TIPM) - Standard Procedure .
  No
  - Go to step 4
CHECK THE (C955) HVAC MUX RETURN CIRCUIT FOR AN OPEN

Fig 3: Measuring Resistance Of HVAC MUX Return Circuit
Courtesy of CHRYSLER LLC
1. Measure the resistance of the (C955) HVAC MUX Return circuit between the A/C Heater Control C1 harness connector and the Cluster C2 harness connector.
  Does the Ohm meter read open circuit?
  
  Yes
  - Repair the (C955) HVAC MUX Return circuit for an open.
  - Perform the BODY VERIFICATION TEST. Refer to DTC-Based Diagnostics/MODULE, Totally Integrated Power (TIPM) - Standard Procedure .
  No
  - Replace the Cluster in accordance with the Service Information.
  - Perform the BODY VERIFICATION TEST. Refer to DTC-Based Diagnostics/MODULE, Totally Integrated Power (TIPM) - Standard Procedure .