Outer Tie Rod End

OUTER TIE ROD END





1. Raise and support the vehicle Maintenance.
2. Remove the tire and wheel assembly.

NOTE: Mark the outer to inner tie rod end for easier installation.

3. Loosen the tie rod end jam nut.
4. Remove the outer tie rod end nut (2).






NOTE: Never use anything other than the specified tool to disassemble the ball joints and tie rods from the steering knuckle. Ball joint seal or knuckle damage can result.

5. Separate the outer tie rod end (1) from the knuckle (3) using tool 9360 (2).

NOTE: Count the number of turns when removing. This will aid in the installation procedure.

6. Remove the outer tie rod end (1) from the inner tie rod.