Power Steering Pump Pulley - Installation

GAS






CAUTION: Do not reuse the old power steering pump pulley it is not intended for reuse. A new pulley must be installed if removed.

1. Replace the pulley (2) if it's bent, cracked, or loose.
2. Install the pulley (2) on the pump (1) using (OTC (R) 7771) power steering pulley installation tool or equivalent (3) making sure it is flush with the end of the shaft. Ensure the tool and pulley remain aligned with the pump shaft.
3. Install the air box assembly Air Cleaner - Installation.
4. Install power steering belt. Serpentine Accessory Drive Belt - Installation
5. Install the fan shroud.
6. Install the washer/coolant reservoir assembly.
7. Install air cleaner housing. Air Cleaner - Installation