Second Row Center and Right Outboard

SECOND ROW CENTER AND RIGHT OUTBOARD

WARNING: To avoid serious or fatal injury during and following any seat belt or child restraint anchor service, carefully inspect all seat belts, buckles, mounting hardware, retractors, tether straps, and anchors for proper installation, operation, or damage. Replace any belt that is cut, frayed, or torn. Straighten any belt that is twisted. Tighten any loose fasteners. Replace any belt that has a damaged or ineffective buckle or retractor. Replace any belt that has a bent or damaged latch plate or anchor plate. Replace any child restraint anchor or the unit to which the anchor is integral that has been bent or damaged. Never attempt to repair a seat belt or child restraint component. Always replace damaged or ineffective seat belt and child restraint components with the correct, new and unused replacement parts listed in the Chrysler Mopar (R) Parts Catalog. Failure to follow these instructions may result in possible serious or fatal injury.





1. Remove the four screws (1) that secure the second row seat cushion legs (8) to the rear floor panel (9).
2. Lift the front edge of the seat cushions (10) up against the seat backs for access to the forward end of the right center seat bracket (7).
3. Remove the screw (6) that secures the lower anchor for the center and right seat belt buckle unit (2) to the inboard side of the right center seat bracket.
4. Remove the center and right seat belt buckle unit from between the second row seat cushions as a unit.