Parking Brake Lever - Installation

INSTALLATION





1. Install the parking brake lever assembly (3).
2. Install the parking brake lever assembly (3) to the mounting bolts and tighten the nuts (1) to 16 Nm (140 in. lbs.).
3. Engage the front cables to the equalizer.
4. Reconnect the parking brake lamp switch wire (2).
5. If installing a new parking brake lever remove the pin that comes on the lever when shipped.
6. If you are reinstalling the original park brake lever remove the lock out device at this time.
7. Install the occupant restraint controller Occupant Restraint Controller - Installation.
8. Test the parking brake lever.
9. Install the center floor console, Floor Console - Installation.