Instrument Panel Antenna Cable - Removal

REMOVAL

WARNING: Disable the airbag system before attempting any steering wheel, steering column, seat belt tensioner, side airbag or instrument panel component diagnosis or service. Disconnect and isolate the negative battery (ground) cable. Wait two minutes for the airbag system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the airbag system. Failure to follow these instructions may result in accidental airbag deployment and possible serious or fatal injury.

1. Disconnect and isolate the battery negative cable.
2. Remove the instrument panel Instrument Panel - Removal.

CAUTION: Pulling the antenna cable straight out of the radio without pulling on the locking antenna connector could damage the cable or radio.

3. Disconnect the antenna cable from radio by pulling the locking antenna connector (2) away from radio.
4. Disengage each of the retainers that secure the cable to the instrument panel.
5. Remove the cable from the instrument panel.