Instrument Panel Antenna Cable - Installation

INSTALLATION

WARNING: Disable the airbag system before attempting any steering wheel, steering column, seat belt tensioner, side airbag or instrument panel component diagnosis or service. Disconnect and isolate the negative battery (ground) cable. Wait two minutes for the airbag system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the airbag system. Failure to follow these instructions may result in accidental airbag deployment and possible serious or fatal injury.

1. Position the instrument panel antenna cable onto the instrument panel.
2. Engage each of the retainers that secure the cable to the back side of the instrument panel.
3. Connect cable to radio.
4. Install instrument panel Instrument Panel - Installation.
5. Connect the battery negative cable.