C2201

C2201-INTERNAL CONTROLLER

For a complete wiring diagram, refer to the Wiring Information

- When Monitored:
With the ignition on.

- Set Condition:
The Final Drive Control Module has detected a failure internal to the controller.





FINAL DRIVE CONTROL MODULE

NOTE: This DTC may set after updating the controller software. Erase this DTC, cycle the ignition off for 10 seconds and recheck. If this DTC resets, proceed with repair procedure. If it does not reset, repair is complete.

1. The Final Drive Control Module has detected an internal failure.

View repair

Repair

- Replace the Final Drive Control Module.
- Perform the FDCM VERIFICATION TEST, FDCM Verification Test.