Seat Back, Front: Assembly: Assembly

Fig 1: Upper Support Wires

Courtesy of CHRYSLER LLC

Before proceeding with the following repair procedure, review all warnings and cautions. See Body/Seats - Warning
Place lumbar mat onto seat back frame and insert the upper support wires (1) into the frame.

Fig 2: Lower Support Wires
Courtesy of CHRYSLER LLC
Squeeze the lower support wires (1) together and insert into the lower frame.

Fig 3: Side Support Wires
Courtesy of CHRYSLER LLC
Squeeze the side support wires together and insert them into the sides of the seat back frame.

Fig 4: Lumbar Cable
Courtesy of CHRYSLER LLC
Connect the lumbar cable housing (1) and connect the cable end (2) to the anchor.

Fig 5: Lumbar Adjuster Screws
Courtesy of CHRYSLER LLC
Install the lumbar adjuster and install the adjuster screws (1).

Fig 6: Seat Back Hog Rings
Courtesy of CHRYSLER LLC
Position the seat back cushion on the frame and position the cover over the cushion.
Attach the seat cover (3) to the seat back cushion (1) and install new hog rings (2) as required.

Fig 7: Seat Cover Push-Pin Fasteners & Hooks
Courtesy of CHRYSLER LLC
Install the push pins (1) and connect the inner cover to the hooks (2).

Fig 8: Seat Cushion J-Straps
Courtesy of CHRYSLER LLC
Install the push-pin fasteners (2) and connect the J-straps (1).

Fig 9: Headrest Sleeves
Courtesy of CHRYSLER LLC
Install the headrest sleeves (2).

Fig 10: Headrest
Courtesy of CHRYSLER LLC
Position the seat back panel (1) onto the seat back (2) and seat fully.

Fig 11: Headrest Release Tabs
Courtesy of CHRYSLER LLC
Press the headrest sleeve release buttons and install the headrest.
Install the seat back. See Body/Seats/SEAT BACK - Installation .