Reservoir, Power Steering Pump - Removal

REMOVAL

NOTE: Before proceeding, Service Precautions .

1. Remove engine appearance cover.
2. Remove the fasteners securing the coolant recovery bottle to its mounts and move it away from the power steering fluid reservoir. It is not necessary to disconnect the coolant recovery bottle fluid lines. Coolant Recovery Bottle - Removal




3. Siphon as much fluid as possible from the power steering fluid reservoir (5).
4. Remove hose clamp securing cooler return hose (3) to fluid reservoir fitting. Slide the hose off the end of the reservoir fitting.
5. Remove hose clamp securing pump supply hose (4) to the fluid reservoir fitting. Slide the hose off the end of the reservoir fitting.
6. Remove the reservoir mounting screw (1) used to secure the reservoir in place.
7. Remove the reservoir (5).
8. Remove the plastic shield from the reservoir.