Outer Tie Rod End

OUTER TIE ROD END





1. Raise and support the vehicle. Service and Repair
2. Remove the wheel mounting nuts (3) , then the tire and wheel assembly (1).





3. Loosen the tie rod jam nut (5).
4. Remove the nut (2) attaching the outer tie rod (4) to the knuckle (3). To do this, hold the tie rod end stud with a wrench while loosening and removing the nut with a standard wrench or crowfoot wrench.





5. Release the tie rod end (3) from the knuckle (2) using Remover, Special Tool 9360 (1)
6. Remove the outer tie rod (3) from the knuckle (2).

NOTE: When unscrewing the outer tie rod from inner, count the number of revolutions to take it off. This action will aid in installation, getting the toe close to where it needs to be when setting the wheel alignment.

7. Remove the outer tie rod from the inner tie rod.