Rear Door Carrier Plate - Removal

REMOVAL





1. Raise the door glass (1) into the position shown and disconnect the glass from the regulator (2), Rear Door Glass - Removal.
2. Tape the glass (1) into the full up position.





3. Remove the speaker (2), Speaker - Removal.





4. Disconnect the exterior handle rod (1) from the latch (3).





5. Remove the latch screws (3).





6. Remove the trim screws (3) from the speaker opening.
7. Remove the trim cap (4) and the screw (2) at the inside handle.





8. Loosen the lower screw (2).





9. Disconnect the main harness connector (1).
10. Remove the screws (3) from the door frame.





11. Remove the three upper fasteners (1).





12. Lift the module (1) up off of the four trim hooks (2) and lower regulator screw (4).
13. Pull the front of the trim module (1) out from the door and forward to remove the latch.





14. Separate the harness (2) from the door.