Front Hub and Bearing - Installation

INSTALLATION





1. Install the hub bearing (3) to the knuckle then tighten the 3 bolts to 115 Nm (85 ft. lbs.).
2. Install the wheel speed sensor (1) into the hub (3) and then install the mounting bolt (2) and tighten to 12-14 Nm (106-124 in. lbs.). Front.










3. Install the brake rotor (1) Brake Rotor - Installation.










4. Install the brake caliper adaptor (1) Disc Brake Caliper Adapter - Installation.





5. Install the caliper (1) Disc Brake Caliper - Installation.

6. Install the wheel and tire assembly Procedures.
7. Remove the support and lower the vehicle.