Left Side

LEFT SIDE

NOTE: All torques should be done with vehicle on the ground with full vehicle weight.










1. Position the upper suspension arm (2) in the frame rail bracket.
2. Install the mounting bolt (7) and nut (1) tighten to 129 Nm (95 ft. lbs.).










3. Position the upper suspension arm (4) in the axle bracket.
4. Install the mounting bolt (3) and nut (2) tighten to 136 Nm (100 ft. lbs.).
5. Raise the fuel tank back into place and secure Fuel Tank - Installation.
6. Remove the supports and lower the vehicle.