LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2008 >> Compass Limited, FWD, Automatic CVT >> Repair and Diagnosis >> Engine Mechanical >> Blowers, Superchargers & Turbochargers >> Exhaust System & Turbocharger >> Turbocharger System >> Lines And Hoses >> Removal >> Lines And Hoses >> Oil Supply Line

Oil Supply Line

Fig 1: Turbocharger Brackets And Heat Shields
GC0019350Courtesy of CHRYSLER LLC
1 - UPPER/LOWER HEAT SHIELDS
2 - TURBOCHARGER SUPPORT BRACKET
3 - ELBOW
4 - ELBOW SUPPORT BRACKET
  1. Raise vehicle on hoist.
  2. Remove elbow support bracket.
  3. Disconnect oil supply line flared fitting from brass fitting at engine block.
  4. Lower vehicle.
  5. Disconnect oil supply line flared fitting from brass fitting at turbocharger.
  6. Remove oil supply line.
Fig 2: Oil Supply Line - Engine Block Fitting
GC0019369Courtesy of CHRYSLER LLC
1 - OIL SUPPLY LINE
2 - FLARED FITTING - 31 N.m (23 ft. lbs.)
3 - BRASS FITTING - 41 N.m (30 ft. lbs.)
4 - BRASS FITTING - 41 N.m (30 ft. lbs.)
5 - FLARED FITTING - 31 N.m (23 ft. lbs.)
6 - OIL COOLER COOLANT LINE
scientia non olet · About LEMON Manuals