LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2008 >> Compass Limited, AWD, Standard >> Repair and Diagnosis >> Engine Mechanical >> Blowers, Superchargers & Turbochargers >> Exhaust System & Turbocharger >> Turbocharger System >> Cooler-Charge Air And Hoses >> Installation >> Charge Air Cooler-Hoses >> Hose - Charge Air Cooler To Throttle Body

Hose - Charge Air Cooler To Throttle Body

Fig 1: Charge Air Cooler Hose
GC0019348Courtesy of CHRYSLER LLC
1 - CHARGE AIR COOLER
2 - HOSE - TURBOCHARGER TO CHARGE AIR COOLER
3 - NUT
  1. Position hose to mounting location.
  2. Connect hose to throttle body.
  3. Connect hose to charge air cooler.
  4. Tighten hose clamps to 1.7 N.m (15 in. lbs.).
  5. Connect Throttle Inlet Pressure (TIP) hose to charge air cooler hose.
  6. Connect Inlet Air Temperature (IAT) sensor connector.
  7. Install battery tray support bracket.
  8. Install battery tray and battery. Refer to INSTALLATION .
  9. Connect positive battery cable.
  10. Connect negative battery cable.
  11. Install air cleaner housing. Refer to INSTALLATION for 2.0L. Refer to INSTALLATION for 2.4L.
scientia non olet · About LEMON Manuals