LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2008 >> Compass Limited, AWD, Automatic CVT >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (2.0L Engine (Service Information)) >> Lubrication >> Switch-Oil Pressure >> Removal >> Removal

Switch-Oil Pressure: Removal: Removal

WARNING: This page is about a different variant/trim than selected.
NOTE: If the oil pressure switch is removed, it must be replaced with a new  switch.
Fig 1: A/C Compressor - R & I
GC0082737Courtesy of CHRYSLER LLC
  1. Disconnect and isolate the negative battery cable.
  2. Raise and support the vehicle.
  3. Remove the front skid plate, if equipped.
  4. Remove the splash shield from the right side frame rail. Refer to Body/Exterior/SHIELD, Splash - Removal .
  5. Remove the accessory drive belt. Refer to Cooling/Accessory Drive/BELT, Serpentine - Removal .
  6. Remove the three bolts (2) and reposition the A/C compressor (1).
    Fig 2: Oil Sender
    GC0098664Courtesy of CHRYSLER LLC
  7. Disconnect the oil pressure switch electrical connector.
  8. Remove the oil pressure switch using Oil Pressure Socket C-4597 (1) or equivalent and discard the switch.
scientia non olet · About LEMON Manuals