LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2008 >> Compass Limited, AWD, Automatic CVT >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (2.0L Engine (Service Information)) >> Cylinder Head >> Tappets-Valve >> Standard Procedure >> Measuring Valve Lash >> Clearance Too Small

Clearance Too Small

WARNING: This page is about a different variant/trim than selected.
Fig 1: Tappet Identification
GC0054626Courtesy of CHRYSLER LLC
  1. Remove camshafts. See REMOVAL .
  2. Specification - clearance = change.
  3. Decrease tappet thickness by change figure.
  4. Install camshafts. See INSTALLATION .
  5. Verify that valve lash is correct.
scientia non olet · About LEMON Manuals