LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2008 >> Compass Limited, AWD, Automatic CVT >> Repair and Diagnosis >> External Pages >> Different car >> Section 56 (DTCS P0223 To P0352 (Gas)) >> P0341-Camshaft Position Sensor Performance-Bank 1 Sensor 1 >> Possible Causes

Possible Causes

WARNING: This page is about a different car, the 2009 Jeep Patriot and 2009 Jeep Compass. However, it is still accessible from the selected car via links, so may be relevant.
Possible Causes 
INTERMITTENT DTC
(K857) 5 VOLT SUPPLY CIRCUIT SHORTED TO VOLTAGE
(K44) CMP 1/1 SIGNAL CIRCUIT SHORTED TO VOLTAGE
(K857) 5 VOLT SUPPLY CIRCUIT SHORTED TO GROUND
(K44) CMP 1/1 SIGNAL CIRCUIT SHORTED TO GROUND
(K857) 5 VOLT SUPPLY CIRCUIT SHORTED TO THE (K44) CMP 1/1 SIGNAL CIRCUIT
(K857) 5 VOLT SUPPLY CIRCUIT SHORTED TO THE (K900) SENSOR GROUND CIRCUIT
(K44) CMP 1/1 SIGNAL CIRCUIT SHORTED TO THE (K900) SENSOR GROUND CIRCUIT
(K857) 5 VOLT SUPPLY CIRCUIT OPEN OR HIGH RESISTANCE
(K44) CMP 1/1 SIGNAL CIRCUIT OPEN OR HIGH RESISTANCE
(K900) SENSOR GROUND CIRCUIT OPEN OR HIGH RESISTANCE
CAMSHAFT 1/1 POSITION SENSOR
CAMSHAFT 1/2 POSITION SENSOR
POWERTRAIN CONTROL MODULE (PCM)

Always perform the Pre-Diagnostic Troubleshooting procedure before proceeding. See  DTC-Based Diagnostics/MODULE, Powertrain Control (PCM) - Standard Procedure