LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2008 >> Compass Limited, AWD, Automatic CVT >> Repair and Diagnosis >> External Pages >> Different car >> Section 35 (Ignition Control (Service Information)) >> SENSOR, Camshaft Position >> Removal >> Rear

SENSOR, Camshaft Position: Removal: Rear

WARNING: This page is about a different car, the 2009 Jeep Patriot and 2009 Jeep Compass. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: REAR CAM SENSOR SHIELD INSTALLED
GC0082376Courtesy of CHRYSLER LLC
  1. Disconnect negative battery cable.
  2. Disconnect electrical connector at sensor.
  3. Remove nut retaining heat shield.
    Fig 2: REAR CAM SENSOR SHIELD REMOVED
    GC0082377Courtesy of CHRYSLER LLC
  4. Pull heat shield out to uncover sensor.
  5. Remove mounting bolt.
    Fig 3: CAM SENSOR
    GC0082375Courtesy of CHRYSLER LLC
  6. Remove sensor.
scientia non olet · About LEMON Manuals